How to easily run a halfway format on any laptop and desktop
Below are few simple steps, on how you can easily run a halfway format on any computer weather desktop or laptop.
Please before you even think of embarking on this method of formatting,make sure you have a little knowledge about it, and with these steps you are good to go.
NOTE: We don’t just run a halfway formatting just because we want to ‘NO’,
Below are few reasons why we run a halfway format.
*When a laptop/desktop cant detect the flash drive due to USB pot, might have develop minor fault, or maybe you are finding it difficult to run the format on one particular laptop/desktop, or maybe you don’t know the boot menu button.
Or when the CD ROM, cant load very well E.T.C.
Now lets proceed to the simple steps on how you can get it done.
First step: Remove the Hard disk drive,[HDD], or San disk [SSD]from that particular laptop/desktop which have the above listed fault and then insert it to other perfectly working computer that you wish to run the format, make sure that the HDD or the SSD is properly connected to avoid shacking, which may end up intercepting the formating.
Then after that, power on your computer, and press the apropriate boot menu button.
Note: Each company have their different boot menu button, Like HP boot menu is F9 and DELL is F12.
Second step: After clicking on the appropriate boot menu button, it will take you to where you have to select your boot option, assuming, if your using CD plate to run the format, just select CD ROM, and if your using flash drive, then select USB MASS STORAGE.like in the picture below;
After selecting your boot option, it will take you to where you will have to select your language and also to where you will select and delete the particlar files you wish to remove.
Just contune with the normal way you format your laptop/desktop, untill it get to this place in the photo below.
Pls at this point you have to be vigilant, when the stop running and turn off it self , act quickly by long pressing the power button, for the laptop to shut down, if it is desktop you can easily disconnect the wire from the power pack, and then remove the flash drive, but if your making use of CD plate you can leave it there.
Congratulation, because you have just finished the first chapter.
Now lets proceed to the second chapter.
At this stage, you have to remove the HDD or SSD again and insert it into the previous laptop/desktop, always make Sure it is done properly to avoid corrupting.
when you have properly inserting the HDD or SSD, then power on your computer, and i know you will be suprise to see your computer resuming from where it stopped before,
NOTE: Dont click on any button after powering on your computer pls allow it to run by itself, unless it requested that you do so
When it finally returns to this stage in the picture below.
From here you can contune with the normal way you format your laptop.
Pls if you have any questions or need any assistance dont hestate to contact us,